wire mesh loomIt is a kind of crocheted hook net made of low carbon steel wire, stainless steel wire, aluminum alloy wire, PVC wire and plastic coated wire. It has the characteristics of uniform mesh, smooth mesh surface, beautiful appearance, narrow adjustable width of net, adjustable wire diameter, long corrosion life, simple weaving, beautiful and practical.

wire mesh loomIt has the characteristics of high production efficiency and stable mechanical performance. The use of well-known brand servo system, so that the failure rate is greatly reduced, the performance tends to be stable, and the cutting position is more accurate. Reducer part: precision planetary reducer machine, high durability, low noise.

wire mesh loomThe main work and matters needing attention when starting up
1. Open the main water supply pipeline before starting the metal wire mesh machine, and drain the water first to prevent the residual sewage in the pipeline from entering the water tank, pump body and nozzle.
2. Wet the yarn at the weaving mouth, reed and heddle with water to soften the residual slurry and prevent the residual hard slurry from pulling and breaking the yarn when driving directly.
3. Turn on the power supply of the metal wire braiding machine, plug in the circuit control board, open the water supply valve of the water tank, try to supply electricity and water, and observe whether the water and electricity are normal.
4. Adjust the tension of the warp silk, and turn the spindle dial by hand to see if the spraying, beating-up and lifting are normal.
5. If it is necessary to change the variety and specification of the blank silk, the weft yarn and suitable let-off and coiling gears can be changed to change the weft density.
6, ifwire mesh loomThe slug at the reed heddle is serious, causing fluffing of the sutra filaments, etc. You can manually shake the sutra filaments through the weaving mouth for several centimeters to more than ten centimeters, and then try driving again depending on the specific situation.
7. If the above main work is done well, after checking that everything is normal, you can start the operation according to the normal procedure.