Jin Gang Mesh Braiding Machine Manufacturer: The assembly of paver accessories has always been the primary problem affecting paving. The speed and quality of assembly have also always been difficult problems for mechanics. First of all, the assembly parts should be selected, the connecting end should be cleaned, and the assembly principle should be: first inside, then outside, first large and then small. Before assembly, place the left and right accessories in the corresponding positions and mark them to lay a good foundation for later assembly, so that they can be assembled and debugged quickly.

Gold steel mesh braiding machine manufacturer: 1 stirring shaft

When the auger shaft is engaged with the auger hanger, the corresponding auger front baffle shall be installed first. After the vertical support, cross support and auger front baffle of the auger front baffle are preliminarily installed, the distance from both ends of the auger baffle to the rammer front baffle (the distance shall be consistent) and the levelness of the auger front baffle (shall be horizontal) shall be measured, when installing the auger shaft, the position of the auger shaft can be ensured.

Gold Steel Mesh Braiding Machine Manufacturer: Two Blades

The diesel engine shall be turned off before installing the spiral blade, and the pedal grille shall be installed immediately after the spiral extension section is assembled to meet the paving requirements.

In the factory, the installation of spiral blades ensures the material to be transported outward, and the conveying direction is marked by the arrows on the blades. When the spiral blades are installed correctly, the arrows on the left and right spiral blades point to the outside, close to the distributor bearing seat, and assemble the claw-shaped blades on the middle right to ensure the material to be transported inward. If this layout is selected, the surface structure of the area under the distribution box will be obviously improved when laying a certain material, when paving a large working width, the extension of the material distribution rod is 1.0~4.0m, which is respectively assembled on the baffle bracket outside the main engine.

When the width of the paving operation is less than or equal to 3m, the blade at the bearing end of the basic distributor is usually removed and sheathed, which can reduce the wear of the shaft and blades.

Gold steel mesh weaving machine manufacturer: what are the maintenance methods for paver parts failure?

There are many kinds of paver accessories, and each kind of accessories has its functional purpose in the field of non-construction machinery industry. When in use, such accessories should be checked frequently and regular maintenance should be carried out to ensure the long-term use of the products and extend the cycle life of accessories series products. As one of the accessories of gear pump, sometimes there will be pump failure, oil seal washed out, oil leakage and so on. What is the reason?

If the paver accessories pump out of oil, we will cooperate with the investigation and treatment of gear pump inlet fault maintenance, the first thing to detect is the filter screen, to see if there is any blockage caused by impurities, if it is blocked, it is necessary to remove impurities in time, otherwise the oil can not be sucked out.

There are three main reasons for paver accessories in emergency situations. For example, the oil seal is washed out or oil leaks. One is that the rotation direction of the gear pump is problematic and needs to be adjusted in time; the second is that the bearing of the gear pump is subjected to axial force; third, The radial force of the gear pump exceeds the load, which will cause the oil seal to flush out and leak oil.