Fully automatic weaving machine is also called netting machine, wire mesh weaving machine. It can realize the process of wire or plastic wire of various materials, pvc wire and so on from wire to net. Can be realized in various materials wire or plastic wire, PVC wire. Automatic weaving machine is a large-scale weaving machine enterprise produced by Raoyang County Jinglian Machinery Manufacturing Co., Ltd.
There are many types of automatic weaving machines, which can be divided into shuttle weaving machines, shuttleless weaving machines, ginning machines (ginning machines), ginning machines (ginning machines/diamond machines), coal mine support network weaving machines (coal mine support net machines).
The shuttle loom is a double-bar beating-up machine for weft insertion. The woven silk screen is wrapped, that is, the whole weft is a yarn, which can weave flat nets with less than 200 yarns.
Shuttleless weaving machine for shuttleless sword belt weft, weft monofilament weaving, divided into hot edge, fold edge two kinds. Different models can be divided into arch heddle (zeng), hanging heddle two kinds, double heddle four heddle weaving, a card weft, two card weft.
The rolling loom is designed to weave large silk diameters, and the crochet machine is a machine that wrings the thread into a spiral and then performs crochet through a net.
Coal mine support net valve core is used for coal mine support false roof, weaving large wire diameter large mesh warp and weft yarn see machine support net machine.
Raoyang County Jinglian Machinery Manufacturing Co., Ltd. automatic weaving machine production process operation procedures and quality control skills
1, production process operation procedures.
Fix the semi-finished product to be knitted on the open wire frame, fix the open wire reel, and adjust the tension. The cable core is unloaded from the pay-off reel, enters from the lower part of the host, passes through the center hole of the reel, reaches the traction wheel for several turns through the guide wheel, and then leads to the reel. The position of the guide wheel should enable the cable center to pass through the reel center. Select and install the traction suspension device. Arrange the spindles within the weaving shuttle. After the inspection is correct, the machine can be turned on for a period of time after shutdown, and the process parameters such as knitting outer diameter and weaving pitch are measured to meet the process requirements, and normal production can only be achieved after they are qualified.
2. Quality control in production.
During the weaving process of the high-speed knitting machine, the machine suddenly stopped because the thread was broken or the thread was used up. After the corresponding processing, you can boot to continue weaving.
During the preparation process, if it is found that the shielding layer under weaving does not meet the legal requirements, it can be required to stop at any time to remove the weaving of metal wires on this period of time, and then resume normal weaving after disposal.
497 Control the technical process design parameters and record the relevant inspection results in accordance with the provisions of the process card sent to the workshop machine.
A complete reel needs to be end to end. If there is a seam inside the cut, the reason should be indicated in the middle of the mark and the length of the front. The wire grid shall be arranged neatly and tightly, and there shall be no upper and lower crossing.