Automatic weaving machine, also known as netting machine, wire mesh weaving machine. It can realize the process from metal wire to mesh, such as metal wire or plastic metal wire, pvc wire and so on. Let's say, what should we pay attention to in the long-term operation of the automatic weaving machine?
Some parts of the automatic weaving machine, such as the main shaft bracket and the sliding seat, must ensure the accurate distance between the sliding seat and the lower main shaft braiding line after maintenance, disassembly or replacement of new parts and reassembly. It is recommended to install the carriage and its connected upper shaft on the sliding turntable so that during the process from the swing bar to the knitting point, the lower needle thread will not be caught or cut by the carriage.
During rough adjustment, the spindle is placed on the two adjacent outer spindle supports, and the braided wire is guided to its own braiding point through the swing rod, and the braided wire is overlapped tightly. When the braided wire enters or comes out of the slot on the sliding turntable track, the distance from the edge of the upper spindle sliding frame should be basically equal. The adjustment of the distance can be achieved simultaneously by constantly changing the gear carrier forward or backward and also by controlling one or several gears. If the movement as a tooth cannot reach a more accurate adjustment distance, fine adjustment can be made according to the following steps: loosen the five fixing screws on the inner ring gear. since the through hole is elliptical, fine adjustment of the relative sliding frame can be achieved by moving the inner ring gear. after the adjustment is in place, tighten the screws. Place the rest of the sliding frame evenly on the sliding ring track. If the swing technology of the braided line of the new swing rod is highly valued after installation, it should be adjusted to all other swing rods with a certain same stop point.
When the automatic weaving machine is in production, the equipment can be in operation for a long time, and the static deformation and dynamic deformation of the machine are constantly changing in time, which makes the local error and system design error of the components that have been fastened or connected gradually increase. Whether the machine is running or not, its static shape will always exist. After the operation, a dynamic deformation is added. These two kinds of deformation make the thread of the nut and the screw deform, causing the students to gradually loosen the combination, the gasket becomes thinner after being squeezed, the elastic force of the spring washer decreases, and so on.
Check whether the key process components and fastening connectors of each machine are loose, and tighten the loose parts in time. Purchase standard fastening joints from a nationally designated factory. Unify the fastening operation method of fasteners to avoid over-tightening or over-tightening, which may cause failure or shorten the service life of fasteners.
In order to maintain the performance of the equipment, check the equipment according to the standard, so as to find the abnormal state of the equipment as soon as possible, and establish an inspection system to check the weft is an important means of maintenance work. The so-called sampling inspection refers to the inspection of key parts and items of equipment. If every part of the daily operation of each piece of equipment is checked every day, the state maintenance is always incomplete.