Nowadays, the level of various fields is getting higher and higher, and the problem of anti-fouling of machinery and equipment has also caused many people to attach great importance to it.wire mesh loomThe display has replaced the influence of general weaving skills, the difficulty coefficient of manual service weaving is large, the consumption of human resources and material resources has disappeared, and the output power is not high. A knitting machine that works 24 hours a day can produce dozens or even hundreds of times the output power of technical weaving.

wire mesh loomBefore the machine is finished, the beam is not finished, but it takes a long time to stop (more than a week). In order to ensure that all aspects of the wire braiding machine are normal and smooth when it is restarted, the following main tasks and precautions need to be done:
wire mesh loomMain work and operation points during shutdown
1. When the metal wire weaving machine is stopped, the blank silk woven on the machine should be dropped to prevent it from being placed on the machine for a long time and becoming damp and moldy.
2. Rinse the slurries accumulated on the reed and heddle with water and clean them as much as possible to lay a good foundation for starting the machine later.
3. Relax the tension of the mercantiles, take down the heavy hammer, and shake the heald frame into a level state to prevent the mercantiles from stretching for a long time.
4. Put down and cover the water baffle and waterproof cover on the loom.
5. Lift up the lifting rod of the weft pressing wheel to prevent deformation of the weft pressing wheel.
6, willwire mesh loomCut off the power supply of the machine, turn off the water source, pay attention to safety and save energy.
7. Take out the circuit control board inside the electrical box and store it in a ventilated and dry place to prevent moisture from affecting its efficacy.
8. For example, if all wire braiding machines in a workshop need to stop, cut off the main power supply and turn off the main water source, and regularly ventilate and drain moisture to check the situation, so as to keep the workshop ventilated and dry.